The configuration of segmented blade and cut-ting modes is selected based on the strength of natural stone and type of equipment. One of the important parameters of cutting is linear cutting speed, compliance with which ensures optimal performance of the diamond layer of the blade.
Recommended linear cutting speed in the processing of natural stone
The configuration of segmented blade and cut-ting modes is selected based on the strength of natural stone and type of equipment. One of the important parameters of cutting is linear cutting speed, compliance with which ensures optimal performance of the diamond layer of the blade.The revolution speed of working shaft can be chosen based on the recommended linear cutting speed and diameter of the cutting blade, by calculation or according to the table.
Conversion table of linear cutting speed for blades 300-600 mm in diameter
To achieve maximum performance efficiency on stationary equipment follow the recommendations set forth in the table:
The service life of the core depends not only on cutting modes, but also the accuracy of the equipment configuration, condition of the mounting and clamping flange.The outer diameter of the flange F should always correspond to used blade’s diameter D.In practice, the diameter clamping flange is chosen by calculating of 1/3 of the external diameter of the blade D. Also an increase in the diameter of the flange F is allowed.If the size of the flange is less than recommended, it is likely to cause irreparable deformation of the blade.Particular attention should be paid to clean work surfaces of mounting and clamping flange.
#concrete #diamondtools #diamonddrilling #demolition #constructionequipment #diamondsawing #concretefloor #reinforcedconcrete #concretecutting #constructionmaterials #concretecutting #brickcutting #cuttingwalls #constructionuk #ukconstruction #buildersuk #drillingholes
Comments